Your crawler fitment worksheet
Record one rig and one proposed change. Fill in what you know, check the details, then download your completed worksheet.
All fields are optional. Use up to 2,000 characters per answer and 18,000 across the worksheet. Unfilled PDF fields are marked “Not recorded”.
1. Identify the rig
Include the exact model number, not just the family name.
Not recorded
Current changes, terrain and any event or class.
Not recorded
Measure at ride height. Identify front and rear links separately.
Not recorded
2. Wheels and clearance
Hex across flats, pin engagement and usable axle thread.
Not recorded
Mounting diameter, width, offset, tire outside diameter and inserts.
Not recorded
Check full steering and suspension movement in both directions.
Not recorded
3. Servo and mount
Case size and mounting-hole spacing.
Not recorded
Spline count/type, horn reach, screw and wire clearance.
Not recorded
Allowed operating voltage and power supply requirement.
Not recorded
4. Electrical system
Cell count, dimensions, connector pinout/polarity and tray fit.
Not recorded
Exact models and the output actually supplying the servo.
Not recorded
Include the receiver, servo, lights and other powered accessories.
Not recorded
5. Candidate and source
Manufacturer, exact part number and selected variant.
Not recorded
Source URL, date checked and what the manufacturer confirms.
Not recorded
Quantity, included hardware, extra adapters and delivered total.
Not recorded
6. Test and decision
Use a repeatable obstacle; record battery and setup.
Not recorded
Record completions, stalls, rubbing or other observable changes.
Not recorded
Keep, adjust or revert, with any new binding, rub or loss of control.
Not recorded
Before ordering or powering up
Tick only the checks you have completed. This is your record, not an automatic compatibility approval.
Crawlers Bot · crawlersbot.com/guides/crawler-fitment-worksheet/